WSPRSONDE-8
Program Files:
Filter-Combiner
Six-Band Filter-Combiner Manual
Beacon Blaster 6
Transmit/Receive Switch Interface
Program Files:
- v1.6.7 allows frequency offset from 0 – 200 Hz (equiv. audio freq 1400 – 1600 Hz)
- Default configuration file name is now “config.txt” (will also look for “commands.txt”)
- “log.txt” file shows timestamped error and status change events.
- Supports WSPR and FST4W-120 (one or the other, not mixed-mode)
- For WSPR operation, the first entry in the “config.txt” file should be “MODE WSPR” (or “mode wspr”)
- Fixes (?) file corruption problem
- In the WSPR mode the 6-meter band now allows operation over same 200 Hz range as on the lower bands.
- There is a shortcut available in the SCHEDULE command, “SCHEDULE A ” followed by the schedule options will set the schedule for all active channels.
- There are additional configuration options in this version
- This fixes a very small timing bug in v.2.3.0, in which the WSPR symbol rate was 0.0075% slow.
- V2.4.0 adds T/R Switch control capability
- Also eliminated the brief transmitter activity at initial start-up
- Increased the maximum CW ID time to 120 minutes (0-60 frames).
Shelf/Low-Pass Filter
User’s Guide:
LPF/Shelf-Filter Users Guide (pdf)
Schematic:
https://turnislandsystems.com/wp-content/uploads/2023/09/Schematic-LPF-Shelf.png
SDR Filter-Preamp
User’s Guide:
Filter-Preamp Users Guide rev-6.pdf
Filter-Preamp Users Guide rev 1 (pdf)
RX-888 External Clock Interface Kit
User’s Guide:
QDX External Clock Interface Boards
User’s Guide:
QDX Clock Interface Board Users-Guide-v2.1b (pdf)